Soroco

Hi Dan mine was a broken wire ion the connector.

any alphardians know the part number for the sliding door lock actuator motor

Hi All I recently had an engine warning light come up on my 07 A10 .fault shown on my JOBDD11 scan tool as (Input shaft sensor A no signal). Got a mobile diagnostic to check but his snap on wont communicate have replaced the sensor with a new one but the fault is still there. Any help would be grateful. ManyThanks

Hi Picasso ,I still have the problem after fitting a new sensor its still showing the same fault no signal. on the scan tool I put a tester on the connections with ignition on and there is no voltage ? any ideas wold be helpful

Hi Picasso. Sorry to be a pest . Could you tell me where abouts the sensors are or a picture

😇

Thanks where will I get them from ?

Hi Picasso. Would this be OK . https://www.ebay.co.uk/itm/195321318366?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=EgGS6wAyTp-&sssrc=2349624&ssuid=M3fpVeoHSGq&var=&widget_ver=artemis&media=COPY

Can you tell me the location of the parts

ANH10 -0174826

Fault cleared with scan tool but recently it has come back. could a blown fuse be responsible ?

Best answer

Hi Dugii I have bought a pair of heated mirror glass but not sure how to connect. I assumed they would be activated by the heated rear screen switch but I'm not sure about the wiring. I checked behind door card and found a spare connector coming to the mirror but not any inside ?. could be this is for side repeaters . I will have to test it for voltage with the rear screen on

Hi does anyone know if the 2007 alphard has the heated mirror wiring pre installed in the doors. I have non heated mirrors fitted but would like to fit the heated ones ?

https://fuseandrelay.com/toyota/alphard.html

Can anyone tell me the colour coded wires that go to the flashing immobiliser key lock . I am considering jumping a flashing led light to it on the dashboard