reset windows after battery replacement

[stewart white]

hi just replaced 12v battery need to reset windows to all work from drivers door can anyone help thanks

[Tricky]

Hi try resetting each window by using its own switch. Put the window fully down by holding the button and once down hold the button for about a further 10 seconds. This should reset each one and this will then let you use the drivers door switch for all windows. Good luck !

[dezufo]

9 hours ago, stewart white said:

hi just replaced 12v battery need to reset windows to all work from drivers door can anyone help thanks

Go to each door and lower the window all the way down and hold the switch for 2 secs then raise the window all the way up and hold switch for 2 secs, they will then work from the drivers door

[stewart white]

OK thanks will try these out 

[MickyC]

Hi dezufo,

You first wind your windows down off their own switches, straight down and then straight up without stopping, they will work of your drivers door switch now...

Good  luck,

Mick

[stewart white]

Hi thanks will give it a go thanks 

[Rojie]

23 minutes ago, stewart white said:

Hi thanks will give it a go thanks 

 

It will work.

 

If you have a moon roof you may need to do the same with that.

[stewart white]

Cheers 

[stewart white]

hi thanks everyone all working again 

[Henry freeman]

go to passenger side wind window down hold down for a few seconds and do up ,repeat on rear windows ,hope this helps you

[stewart white]

Hi thanks all done windows working