MonsterS

I never use auto lights, I found them to be buggy and the sensor often gets glogged up with dirt.

Yeah that would be great. Just to know at what attachement points there are etc. Thank you

I know its an old post but does anyone have pictures of how the tow bar attached to the subframe?

The only place to get a new one is from Toyota Direct which can ship from Japan, but be prepared to pay hundreds of pounds for one. Other than that you can try Aliexpress

Start a new thread for cruise control. Have you enabled it in the computer?

You do not need to get one from Japan, any key blade can be cut and the remote as long as it's the right immobiliser chip will work. Normally you can buy them from Ali express and have a local key place cut it and programme it.

Hi TTCOBALT, please put full details up and price with link.

What are you on about please?

They will need a forklift to remove the axel. Mind was done within 2 hours. A good mechanic will do it quickly.

Please mark the price & add pictures on here.

Wow, that's a great idea.

Try WD59 SGV

Try mp55 rco

Shame, wish i had a gen 2 tohelp bht mineks a gen 1 without power struts.

Check your drum shoes. Mine did the same and found the retaining pins had snapped.

Any luck?

What is the modep of the head unit?

You mean the side doors or the boot? Tue boot cam be adjusted by undoing the bolts on the closing mechanism. The side doors should have guiders to secure them into and a auto pull close motor (this is not the same as the closing motor which can be operated by the driver, ots the final soft close motor) if both doors are the same then look and see you have a fuse gone. Normally it goes and the soft close stops causing a gap at the bottom of the door

If anyone wants the virtual machine which has them all on it let me know it runs on vmware using an old windows xp machine.

What about the simple cruise control?

Behind the speedo.

@Chris.ac Do you have an image of the throttle body and control/actuator. Im having a look at adding it to ours.

I bough a nextbase front and rear, i routed the cables around the trims, pillars etc and then used a mini 2 fuse tap to tap into the 15amp ciggerette fuse on the passenger side fuse box. All works great, then i programmed the dashcam to go off 30 seconds after it lost mains power. Happy to take some pictures if you need it.

Ebay, failing that i'm sure you can solder some wire to override the dead connector.

Actually they should all be on the forum if needed.